Juniper IGP - CONFIGURATION GUIDE V11.1.X, Configuration Manual

Page: 391 / 454

■
Select a value in the range 1–255. A value of 255 means discard the route.
■
Example
host1(config-router)# distance ip 50
■
Use the no version to restore the default value, 115.
■
See distance ip
Configuring Default Routes
You can specify a default route within IS-IS routing domains. You can also suppress
the installation of a default route to level 1-2 routers by level 1 routers.
Optionally, when you issue the default-information originate command and specify
a route map, you can use the map to set a route tag for the default route. Make sure
the route map you specify includes the
set tag command, which defines a tag value
for the default route within the IS-IS domain. For details about configuring and using
route maps, see
JUNOSe IP Services Configuration Guide .
default-information originate
■
Use to generate a default route into an IS-IS routing domain.
■
When you specify a route map with this command and the router has a route
to 0.0.0.0 in the routing table, IS-IS originates an advertisement for 0.0.0.0 in
its LSPs.
■
When you do not specify a route map, the default route is advertised only in
level 2 LSPs.
■
If you specify a route map, you can use the map to set a route tag for the default
route.
■
For level 1 routing, look for the closest level 1-2 router to find the default route.
The closest level 1-2 router is found by looking at the attach bit (ATT) in level 1
LSPs.
■
The default value is disabled.
■
Example1
host1(config-router)# default-information originate
■
Example 2
host1(config-router)# default-information originate route-map map3
■
Use the no version to disable the command.
■
See default-information originate
suppress-default
Configuring Global IS-IS Parameters
■ 367
Chapter 6: Configuring IS-IS