Juniper IGP - CONFIGURATION GUIDE V11.1.X, Configuration Manual

Page: 319 / 454

■
Example
host1(config-router-rn)# message-digest-key 42 md5 0 sal29ute
■
Use the no version to delete the MD5 key.
■
See message-digest-key md5
remote-neighbor
■
Use to configure an OSPF remote neighbor.
■
Use the update-source command to configure source IP address for packets
sent to the remote neighbor. We recommend that you do not leave the update
source unconfigured for a remote neighbor.
■
Example
host1(config-router)# remote-neighbor 10.25.100.14 area 35672
■
Use the no version to remove the remote neighbor and any attributes configured
for the remote neighbor.
■
See remote-neighbor
retransmit-interval
■
Use to set the time between LSA retransmissions for the OSPF remote-neighbor
interface when an acknowledgment for the LSA is not received.
■
Specify a value in the range 1–3600 seconds; the default value is 5 seconds.
■
Example
host1(config-router-rn)# retransmit-interval 10
■
Use the no version to restore the default value, 5 seconds.
■
See retransmit-interval
transmit-delay
■
Use to set the estimated time it takes to transmit a link-state update packet on
the OSPF remote-neighbor interface.
■
Specify a value in the range 0–3600 seconds; the default value is 1 second.
■
Example
host1(config-router-rn)# transmit-delay 3
■
Use the no version to restore the default value, 1 second.
■
See transmit-delay
ttl
Remote Neighbors
■ 295
Chapter 5: Configuring OSPF