Juniper IGP - CONFIGURATION GUIDE V11.1.X, Configuration Manual

Page: 105 / 454

■
There is no no version.
■
See baseline ip udp
baseline tcp
■
Use to set a statistics baseline for all (both IPv4 and IPv6) TCP statistics or for
only IPv4 or IPv6 statistics.
■
The router implements the baseline by reading and storing the statistics at the
time the baseline is set and then subtracting this baseline whenever
baseline-relative statistics are retrieved.
■
Use the ip keyword to implement a baseline for only IPv4 statistics.
■
Use the delta keyword with IP show commands to specify that baselined statistics
are to be shown.
■
Example 1
host1# baseline tcp
■
Example 2
host1# baseline ip tcp
■
There is no no version.
■
See baseline tcp
IP show Commands
You can monitor the following aspects of IP using show ip commands:
Command To Display
“show access-list” on page 82
“show ip as-path-access-list” on page 86
Access lists
“show arp” on page 83 ARP
“show ip” on page 84 General IP information
“show ip address” on page 84 IP addresses
“show ip community-list” on page 87 Community lists
“show ip forwarding-table slot” on page 87
show forwarding-table route-holddown in JUNOSe Command
Reference Guide
Routing table
“show ip interface” on page 88 Interfaces
“show ip interface shares” on page 93 Shared IP interfaces
Monitoring IP
■ 81
Chapter 1: Configuring IP