Juniper IGP - CONFIGURATION GUIDE V11.1.X, Configuration Manual

Page: 331 / 454

■
Seq#—Link-state sequence number (detects old or duplicate LSAs)
■
Checksum—Fletcher checksum of the complete contents of the LSA
■
Area—Area for which data is displayed
■
Router—Number of router LSAs
■
Network—Number of network LSAs
■
Intra-Prefix—Number of intra-prefix LSAs
■
Inter-Prefix—Number of inter-prefix LSAs
■
Inter-Router—Number of inter-outer LSAs
■
Link LSAs—Number of link LSAs
■
Grace LSAs—Number of graceful restart LSAs
■
External LSAs—Number of external LSAs
■
MaxAge—Number of LSAs that have reached the maximum age
■
Area—Area for this LSA
■
LS age—LSA age
■
Options—Optional capabilities supported by this router
■
LS Type—LSA type
■
Link State ID—Link-state ID of the link local LSA
■
Length—Length of the LSA (in bytes)
■
Bit set—Bit set used by this LSA type
■
Link connected to—Type of network to which the link connects
■
Neighboring router’s Router ID—Router ID of the neighboring router
■
Neighboring router’s Interface ID—Interface ID of the neighboring router
■
Local Interface ID—Local interface ID
■
Metric—Cost of this interface
■
Attached Router—Addresses of any attached routers
■
Router Priority—Priority value configured for the router
■
Link Local Address—Originating router's link-local interface address on the
link
■
Prefixes—Prefixes associated with this LSA
■
Number of Prefixes—Number of prefixes associated with this LSA
Monitoring OSPF
■ 307
Chapter 5: Configuring OSPF