Juniper IGP - CONFIGURATION GUIDE V11.1.X, Configuration Manual

Page: 121 / 454

■
Administrative Distance—External, internal, and local administrative
distances
■
Neighbor Address—IP address of the BGP neighbor
■
Neighbor Incoming/Outgoing update distribute list—Number of the
access list for outgoing routes
■
Neighbor Incoming/Outgoing update prefix list—Number of the prefix
list for incoming or outgoing routes
■
Neighbor Incoming/Outgoing update prefix tree—Number of the prefix
tree for incoming or outgoing routes
■
Neighbor Incoming/Outgoing update filter list—Number of filter list for
incoming routes
■
Routing for Networks—Network for which BGP is currently injecting
routes
■
For IS-IS:
■
System Id—6-byte value of the system
■
IS-Type—Routing type of the router: Level 1, Level 2
■
Distance—Administrative distance for IS-IS learned routes
■
Address Summarization—Aggregate addresses defined in the routing
table for multiple groups of addresses at a given level or routes learned
from other routing protocols
■
Routing for Networks—Network for which IS-IS is currently injecting
routes
■
For OSPF:
■
Router ID—OSPF process ID for the router
■
Distance—Administrative distance for OSPF learned routes
■
Redistributing—Protocol to which OSPF is redistributing routes
■
Address Summarization—Aggregate addresses defined in the routing
table for multiple groups of addresses at a given level or routes learned
from other routing protocols
■
Routing for Networks—Network for which OSPF is currently injecting
routes
■
For RIP:
■
Router Administrative State—RIP protocol state. Enable means that the
interface is allowed to send and receive updates. Disable means that
the interface, if it is configured, is not enabled to run yet.
■
System version—RIP versions allowed for sending and receiving RIP
updates. The router version is currently set to RIP1, which sends RIP
version 1 but will receive version 1 or 2. If the version is set to RIP2, the
Monitoring IP
■ 97
Chapter 1: Configuring IP