Juniper IGP - CONFIGURATION GUIDE V11.1.X, Configuration Manual

Page: 345 / 454

■
Priority—Priority value for this interface
■
Designated router—Designated router on this network, if any
■
Backup designated router—Backup designated router on this network, if any
■
Hello—Hello timer value, in seconds
■
Dead—Dead interval timer value, in seconds
■
Wait—Wait interval timer value, in seconds
■
Retransmit—Retransmit interval timer value, in seconds
■
Neighbor Count—Number of neighbors to this interface
■
Adjacent neighbor count—Number of adjacent neighbors to this interface
■
Adjacent with neighbor—Address of the neighbor adjacent to this interface
■
Example
host1# show ip ospf remote-neighbor interface
OSPF remote-neighbor 221.221.221.221 interface configuration:
Update-source loopback0
Remote-neighbor reachable: yes
Area 0.0.0.0
Network type POINT-TO-POINT, No authentication
Cost: 1
Transmit Delay is 1 sec, Interface State POINT-TO-POINT, Priority 1
No designated router on this network
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 221.221.221.221
■
See show ip ospf remote-neighbor interface
show ip ospf spf-log
■
Use to display how often and why the router has run a full SPF calculation.
■
Field descriptions
■
Intra SPF log—Log for SPF calculations run to compute intra-area LSAs
■
Inter SPF log—Log for SPF calculations run to compute interarea LSAs
■
External SPF log—Log for SPF calculations run to compute routes outside
the OSPF routing domain
■
When—Amount of time since a full SPF calculation took place, in
hours:minutes:seconds ; the previous 20 calculations are logged
■
Duration—Number of milliseconds to complete this SPF run; the elapsed
time is in actual clock time, not CPU time
Monitoring OSPF
■ 321
Chapter 5: Configuring OSPF