Juniper IGP - CONFIGURATION GUIDE V11.1.X, Configuration Manual

Page: 341 / 454

■
Example 2
host1# show ipv6 ospf interface
ATM4/0.12 is up, OSPFv3 line protocol is up
Area 0.0.0.0, Intf ID: 0x320004, Instance ID: 0
Link Local Address: fe80::90:1a00:100:80
Interface is active
Network type POINT-TO-POINT
Interface State POINT-TO-POINT
Cost: 1, Priority 1
No designated router on this network
No backup designated router on this network
Timer intervals configured:
Hello 10, Dead 40, Wait 40
Transmit Delay is 1 sec(s)
Retransmit interval is 5 secs
Neighbor Count is 1
FULL Adjacent neighbor count is 1
Adjacent with neighbor 11.0.0.2
FastEthernet0/0 is up, OSPFv3 line protocol is up
OSPF interface configuration:
Interface ID 0.0.1.1
IPv6 link-local address FE80::3/128
IPv6 prefix address 3000::1/64, Area 0.0.0.0
Network type BROADCAST
Cost: 1
Transmit Delay is 1 sec, Interface State BACKUPDR, Priority 1
Designated Router's router ID 1.1.1.1
Backup Designated Router's router ID 2.2.2.2
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 3.3.3.3 (Designated Router)
■
See show ip ospf interface
■
See show ipv6 ospf interface
show ip ospf internal-statistics
show ipv6 ospf internal-statistics
■
Use to display internal OSPFv2 or OSPFv3 statistics, such as allocation failures
for different OSPF components.
■
Use the delta keyword to display statistics relative to the current baseline.
■
Field descriptions
■
LSA bytes allocated—Number of bytes allocated for LSAs
■
Router LSA bytes allocated—Number of bytes allocated for router LSAs
■
Summary bytes allocated—Number of bytes allocated for summary LSAs
■
Neighbor RTX bytes allocated—Number of bytes allocated for neighbor
retransmissions
■
Timers bytes allocated—Number of bytes allocated for OSPF timers
■
Ospf total bytes free—Total number of bytes free
Monitoring OSPF
■ 317
Chapter 5: Configuring OSPF