Juniper IGP - CONFIGURATION GUIDE V11.1.X, Configuration Manual

Page: 199 / 454

host1# show ipv6 neighbors
Interface IPv6-Address Type Hardware Addr State Age
----------------- ----------------- ------- -------------- ----- -----
FastEthernet4/1 1::1 dynamic 0090.1a40.05e5 reach 3
■
Example 2
host1# show ipv6 neighbors summary
Total IPv6 neighbors: 7
By type: 5 global, 2 link-local, 0 anycast, 0 unknown
By state: 5 reachable, 0 incomplete, 2 stale, 0 probe, 0 delay, 0 init
IPv6 address conflicts: 0 during DAD resolution, 0 after DAD resolution
■
See show ipv6 neighbors
show ipv6 profile
■
Use to display information about a specific IPv6 profile.
■
Field descriptions
■
IPv6 profile—Profile name
■
Unnumbered interface—Specifier for the unnumbered interface or none if
the interface is numbered
■
Router—Router name
■
Access Route Addition—Enabled or disabled
■
Source-Address Validation—Enabled or disabled
■
Administrative MTU—MTU size
■
Example
host1# show ipv6 profile foo
IPv6 profile : foo
Unnumbered interface on : loopback 0
Router : r1
Access Route Addition : Enabled
Source-Address Validation : Disabled
Administrative MTU : 0
■
See show ipv6 profile
show ipv6 protocols
■
Use to display configured protocols.
■
Field descriptions
■
Local router ID—Router ID of the local router
■
Local AS—AS number of local router
■
Administrative state—Administrative state of the protocol
■
Operational state—Operational state of the protocol
Monitoring IPv6
■ 175
Chapter 2: Configuring IPv6