Juniper IGP - CONFIGURATION GUIDE V11.1.X, Configuration Manual

Page: 256 / 454

■
Distance—Value added to RIP routes added to the IP routing table. The
default is 120.
■
Number of route changes—Number of times the router has been told
to route changes by its peers
■
Number of route queries—Number of times the router has received route
requests from other routers
■
Update interval—Current setting of the update timer (in seconds)
■
Invalid interval—Current setting of the invalid timer (in seconds)
■
Hold down time—Current setting of the hold-down timer (in seconds)
■
Flush interval—Current setting of the flush timer (in seconds)
■
Route Type—Whether RIP routes are available only for unicast
forwarding, only for multicast reverse path forwarding checks, or for
both
■
Max Ecmp Paths—Number of parallel routes that RIP can support
■
Default-Information originate always—Ability (enabled or disabled) of
RIP to advertise a default route (0.0.0.0/0) if the default route exists in
the IP routing table
■
Triggered Updates—Ability (enabled or disabled) of RIP to send triggered
updates
■
Purge Routes on Interface Down Event—Ability (enabled or disabled) of
RIP to purge the routing table for interfaces that were brought down by
some event
■
Send More Specific Routes—Ability (enabled or disabled) of RIP to send
a less-specific route in preference to a more-specific route if the
less-specific route has a metric
■
Debounce Time—Debounce time for interfaces brought down by some
event
■
Default-Information originate—Ability (enabled or disabled) of RIP to
advertise a default route (0.0.0.0/0) if the default route exists in the IP
routing table
■
route-map—Name of the route map specified for RIP
■
Summary Address—Route that RIP summarizes
■
Network—IP address of a network on which RIP is running
■
Netmask—Network mask applied to the network address
■
Neighbor—Configured neighbor information
■
Address Operational Data
232 ■
Monitoring RIP
JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide