Juniper IGP - CONFIGURATION GUIDE V11.1.X, Configuration Manual

Page: 286 / 454

■
Use the no version to remove this interface from the specified area.
■
See ipv6 ospf area
ip ospf cost
ipv6 ospf cost
■
Use to configure the cost of sending a packet on the network.
■
Cost is a metric value in the range 0–65535; the default value is 1.
■
The router LSA advertises the link-state metric as the link cost.
■
For the IPv6 command, you can specify an optional process ID in the range
1–65535.
■
Example 1
host1(config)# interface fastethernet 0/0
host1(config-if)# ip ospf cost 50
■
Example 2
host1(config)# interface fastethernet 0/0
host1(config-if)# ipv6 ospf cost 50
■
Use the no version to reset the path cost to the default value, 1.
■
See ip ospf cost
■
See ipv6 ospf cost
ip ospf dead-interval
ipv6 ospf dead-interval
■
Use to configure the interval since the last hello packet was seen.
■
Specify an interval in the range 0–2147483647 seconds; the default value is 40
seconds.
■
For the OSPF routers to become adjacent, the dead interval must be identical
on each router.
■
The router’s hello packets advertise this interval.
■
For the IPv6 command, you can specify an optional process ID in the range
1–65535.
■
Example 1
host1(config-if)# ip ospf dead-interval 60
■
Example 2
host1(config-if)# ipv6 ospf dead-interval 60
■
Use the no version to restore the default value, 40 seconds.
262 ■
Configuring OSPF Interfaces
JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide