Juniper IGP - CONFIGURATION GUIDE V11.1.X, Configuration Manual

Page: 259 / 454

No global route map
No table map
Default metric = 1
Distance = 120
Number of route changes = 17
Number of route queries = 2
Update interval = 30 (secs)
Invalid interval = 180 (secs)
Hold down time = 120 (secs)
Flush interval = 300 (secs)
Route Type = both unicast and multicast
Max Ecmp Paths = 4
Default-Information originate always = enabled
Triggered Updates = enabled
Purge Routes on Interface Down Event = enabled
Send More Specific Routes = enabled
Debounce Time = 10
Default-Information originate : disabled
route-map : none
Summary Address: None
Network netmask
Neighbor
No Configured Neighbors
*** Interface Configuration Data***
loopback1
Send version = def
Receive version = def
Authentication mode = none
Default metric = default
Passive Interface = No
Access-list applied to outgoing route = none
Access-list applied to incoming route = none
Route-map applied to outgoing route = none
Copy configuration to dynamic interfaces
*** Address Configuration Data ***
Unnumbered, Rip is up, ATM2/1.18
Dynamic creation and inherits configuration from loopback1
Received bad packet = 0
Received bad routes = 0
Triggered updates sent = 0
Received updates = 3
1.1.1.1, Rip is up, loopback1
Send version = def
Receive version = def
Authentication mode = none
Default metric = default
Passive Interface = No
Access-list applied to outgoing route = none
Access-list applied to incoming route = none
Route-map applied to outgoing route = none
Received bad packet = 0
Received bad routes = 0
Triggered updates sent = 0
Received updates = 0
■
Example 3—Interface configuration data excerpt showing BFD information.
Monitoring RIP
■ 235
Chapter 4: Configuring RIP