Juniper IGP - CONFIGURATION GUIDE V11.1.X, Configuration Manual

Page: 222 / 454

ipv6 nd active-solicitations
■
Use to specify that the router actively solicit neighbors that become stale
(inactive). Normally, when a neighbor entry goes from a reachable state to a
stale state, the router drops traffic until it resolves this neighbor entry. When
enabled, the
ipv6 nd active-solicitations command allows the router to use the
stale neighbor entry while it solicits the neighbor. If the neighbor solicitation
fails, the router removes the entry from the neighbor table and does not use the
neighbor to forward any traffic.
■
Example
host1(config-if)# ipv6 nd active-solicitations
■
Use the no version of this command to disable active solicitations.
■
See ipv6 nd active-solicitations
ipv6 nd managed-config-flag
■
Use to set the “managed address configuration” flag in IPv6 router
advertisements.
■
Example
host1(config-if)# ipv6 nd managed-config-flag
■
Use the no version of this command to clear the flag from IPv6 router
advertisements.
■
See ipv6 nd managed-config-flag
ipv6 nd ns-interval
■
Use to specify the interval, in milliseconds, between IPv6 neighbor solicitation
retransmissions on an interface.
■
Example
host1(config-if)# ipv6 nd ns-interval 500
■
Use the no version of this command to return the interval between neighbor
solicitation retransmission to its default value (zero [0] milliseconds for router
advertisements and 1000 milliseconds for Neighbor Discovery activity of the E
Series router).
■
See ipv6 nd ns-interval.
ipv6 nd other-config-flag
■
Use to set the “other stateful configuration” flag in IPv6 router advertisements.
■
Example
host1(config-if)# ipv6 nd other-config-flag
198 ■
Configuring Neighbor Discovery
JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide