Juniper IGP - CONFIGURATION GUIDE V11.1.X, Configuration Manual

Page: 283 / 454

■
Use to specify the cost metric for the interface. The cost is used in calculating
the SPF routing table and can be in the range 0–65535.
■
The interface can have an IP address, or it can be unnumbered.
■
Example
host1(config-router)# address unnumbered atm 4/0.1 area 3
host1(config-router)# address unnumbered atm 4/0.1 cost 50
■
Use the no version to reset the path cost to the default value, 1.
■
See address cost
address dead-interval
■
Use to specify the time period for the router’s neighbors to wait without seeing
hello packets from the router before they declare the router to be down.
■
The dead interval can be in the range 0–2147483647 seconds, and is advertised
by the router’s hello packets.
■
For the OSPF routers to become adjacent, the dead interval must be identical
on each router.
■
The interface can have an IP address, or it can be unnumbered.
■
Example
host1(config-router)# address 192.168.10.32 area 6
host1(config-router)# address 192.168.10.32 dead-interval 60
■
Use the no version to reset the dead interval to the default value, 40 seconds.
■
See address dead-interval
address hello-interval
■
Use to specify the interval between hello packets that the router sends on the
interface.
■
The hello interval can be in the range 1–65535 seconds.
■
The interface can have an IP address, or it can be unnumbered.
■
Example
host1(config-router)# address 192.168.1.1 area 5
host1(config-router)# address 192.168.1.1 hello-interval 25
■
Use the no version to reset the hello interval to the default value, 10 seconds.
■
See address hello-interval
address passive-interface
■
Use to disable the transmission of routing updates on the interface, meaning
that OSPF routing information is neither sent by nor received through the
interface.
■
The interface can have an IP address, or it can be unnumbered.
Configuring OSPF Interfaces
■ 259
Chapter 5: Configuring OSPF