Juniper IGP - CONFIGURATION GUIDE V11.1.X, Configuration Manual

Page: 85 / 454

■
Use to enable the sending of redirect messages if software is forced to resend a
packet through the same interface on which it was received.
■
Example
host1(config-if)# ip redirects
■
Use the no version to disable the sending of redirect messages.
■
See ip redirects
ip unreachables
■
Use to enable the generation of an ICMP unreachable message when a packet
is received that the router cannot deliver.
■
Example
host1(config-if)# ip unreachables
■
Use the no version to disable the function.
■
See ip unreachables
Specifying a Source Address for ICMP Messages
By default, ICMP uses the IP address of the outgoing interface as the source IP
address for the ICMP message. However, you can use the
ip icmp update-source
command to instruct ICMP to use an already configured interface or a specified IP
address, as the source address of the ICMP message.
For example, you can specify that ICMP use Fast Ethernet interface 1 in slot 0 as the
source for any messages that it sends:
host1(config)# ip icmp update-source fastEthernet 0/1
You must use an already configured interface or an existing IP address when using
the
ip icmp update-source command. Also, you cannot specify a multicast address
when using this command.
ip icmp update-source
■
Use to define an update source address for all ICMP messages that the E Series
router generates from the specified interface.
■
Example
host1(config)# ip icmp update-source 192.35.42.1
■
Use the no version to disable the function.
■
See ip icmp update-source
Internet Control Message Protocol
■ 61
Chapter 1: Configuring IP