Juniper IGP - CONFIGURATION GUIDE V11.1.X, Configuration Manual

Page: 119 / 454

ip si1 is up, line protocol is up
Network Protocols: IP
Virtual Router vr-b:vrf-1
Layer 2 interface atm4/0.1
.
.
.
Out Policed Packets 0, Bytes 0
■
Example 4
host1# show ip interface shares ip si0
ip0 is up, line protocol is up
Network Protocols: IP
Layer 2 interface atm4/0.1
Unnumbered Interface on loopback100
( IP address 202.1.1.1 )
Operational MTU = 1500 Administrative MTU = 0
Operational speed = 155520000 Administrative speed = 0
Discontinuity Time = 0
Router advertisement = disabled
Administrative debounce-time = disabled
Operational debounce-time = disabled
Access routing = disabled
Multipath mode = hashed
In Received Packets 0, Bytes 0
Unicast Packets 0, Bytes 0
Multicast Packets 0, Bytes 0
In Policed Packets 0, Bytes 0
In Error Packets 0
In Invalid Source Address Packets 0
Out Forwarded Packets 101, Bytes 5252
Unicast Packets 101, Bytes 5252
Multicast Routed Packets 0, Bytes 0
Out Scheduler Drops Committed Packets 0, Bytes 0
Out Scheduler Drops Conformed Packets 0, Bytes 0
Out Scheduler Drops Exceeded Packets 0, Bytes 0
Out Policed Packets 0, Bytes 0
■
See show ip interface shares
show ip profile
■
Use to display information about a specific IP profile.
■
Field descriptions
■
IP profile—Profile name
■
IP address—IP address and subnet mask of the interface or none if the
interface is unnumbered
■
Unnumbered interface—Specifier for the unnumbered interface or none if
the interface is numbered
■
Router—Router name
■
Directed Broadcast—Enabled or disabled
Monitoring IP
■ 95
Chapter 1: Configuring IP