Juniper IGP - CONFIGURATION GUIDE V11.1.X, Configuration Manual

Page: 430 / 454

host1# show clns is-neighbors detail
System Id Interface State Type Priority Circuit Id
0000.0000.7500 atm2/0.111 up L1L2 127 0000.0000.0000.00
Area Address(es): 47.0005.80FF.F800.0000.0001.0001
Ip Address(es): 172.30.245.33
■
See show clns
show clns interface
■
Use to display CLNS-specific information about each interface.
■
Field descriptions
■
interface—Status of interface
■
line protocol—Status of the line protocol, up or down
■
Checksums—Status of checksum, enabled or disabled
■
MTU—Maximum transmission size for a packet on this interface
■
Encapsulation—Encapsulation used by CLNP packets on this interface
■
Next ESH/ISH—When the next ES hello or IS hello is sent on this interface
■
Routing Protocol—One or more areas that this interface is in. In most cases,
an interface is in only one area.
■
Circuit type—Whether the interface has been configured for local routing
(level-1), area routing (level-2), or local and area routing (level-1-2)
■
Interface number—Number of the interface
■
local circuit ID—Local circuit ID of the interface
■
Authentication Level-1—If area authentication is enabled, lists key-id, type
of authentication, start and stop accept times, and start and stop generate
times for the key. An asterisk after the type indicates the key is active.
■
Authentication Level-2—If domain authentication is enabled, lists key-id,
type of authentication, start and stop accept times, and start and stop
generate times for the key. An asterisk after the type indicates the key is
active.
■
Level 1 and level 2 metrics—Metric value for each level
■
DIS priority—DIS priority value assigned to the IS-IS router at each level
■
Priority—Priority value assigned to the IS-IS router at each level
■
Circuit ID—Circuit ID of the IS-IS router at each level
■
Number of active level 1 and level 2 adjacencies—Number of adjacencies
active at each level
■
Designated IS—Name of the designated IS-IS router at each level
406 ■
Monitoring IS-IS
JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide