Juniper IGP - CONFIGURATION GUIDE V11.1.X, Configuration Manual

Page: 165 / 454

■
p—Parameter problem
■
S—Source beyond scope
■
t—Hop limit expired (TTL expired)
■
Example
host1# ping ipv6 1::1
■
There is no no version.
■
See ping
traceroute ipv6
■
Use to discover the routes that router packets follow when traveling to their
destination.
■
You can specify:
■
Destination IPv6 address
■
Source interface for each of the transmitted packets
■
Source IPv6 address for each of the transmitted packets
■
Maximum number of hops of the trace and a timeout value
■
Size of the IPv6 packets (not the ICMP payload) in the range 0–64000 bytes
sent with the
traceroute command. Including a size might help locate any
MTU problems that exist between your router and a particular device.
■
Hop count in the range 1–255; the default is 32
■
You can also force transmission of the packets on a specified interface regardless
of what the IPv6 address lookup indicates.
■
Example
host1# traceroute ipv6 1::1 timeout 10
■
There is no no version.
■
See traceroute
Configuring Shared IPv6 Interfaces
You can create multiple shared IPv6 interfaces over the same layer 2 logical
interface—for example, atm 5/3.101—enabling more than one IPv6 interface to
share the same logical resources.
For additional information about shared interfaces, see “Configuring Shared IPv6
Interfaces” on page 141
.
To share IPv6 interfaces:
Configuring Shared IPv6 Interfaces
■ 141
Chapter 2: Configuring IPv6