Juniper IGP - CONFIGURATION GUIDE V11.1.X, Configuration Manual

Page: 123 / 454

Redistributing: isis
Address Summarization:
None
Routing for Networks:
192.168.1.0/255.255.255.0 area 0.0.0.0
Routing Protocol is “ rip”
Router Administrative State: enable
System version RIP1: send = 1, receive = 1 or 2
Update interval: 30 seconds
Invalid after: 180 seconds
hold down time: 120 seconds
flushed interval: 300 seconds
Filter applied to outgoing route update is not set
Filter applied to incoming route update is not set
No global route map
Distance is 120
Interface Tx Rx Auth
fastEthernet0/0 1 1,2 none
Redistributing: ospf
Routing for Networks:
192.168.1.0/255.255.255.0
■
See show ip protocols
show ip redistribute
■
Use to display configured route redistribution policy.
■
Field descriptions
■
To—Protocol that routes are distributed into
■
From—Protocol that routes are distributed from
■
status—Redistribution status
■
route map number—Number of the route map
■
Example
host1# show ip redistribute
To ospf, From static is enabled with route map 4
To ospf, From connected is enabled with route map 3
■
See show ip redistribute
show ip route
■
Use to display the current state of the routing table, including routes not used
for forwarding.
■
You can display all routes, a specific route, best route to a resolved domain name,
all routes beginning with a specified address, routes for a particular protocol
(BGP, IS-IS, OSPF, or RIP), locally connected routes, internal control routes, static
routes, or summary counters for the routing table.
■
Field descriptions
Monitoring IP
■ 99
Chapter 1: Configuring IP