Juniper IGP - CONFIGURATION GUIDE V11.1.X, Configuration Manual

Page: 287 / 454

■
See ip ospf dead-interval
■
See ipv6 ospf dead-interval
ip ospf hello-interval
ipv6 ospf hello-interval
■
Use to configure the interval between hello packets.
■
Specify an interval in the range 1–65535 seconds; the default value is 10 seconds.
■
For the OSPF routers to become adjacent, the hello interval must be identical
on each router.
■
For the IPv6 command, you can specify an optional process ID in the range
1–65535.
■
Example 1
host1(config-if)# ip ospf hello-interval 8
■
Example 2
host1(config-if)# ipv6 ospf hello-interval 8
■
Use the no version to restore the default value, 10 seconds.
■
See ip ospf hello-interval
■
See ipv6 ospf hello-interval
ipv6 ospf mtu-ignore
■
Use to specify that the interface disregard the MTU size contained in the data
description packet.
■
When enabled, the interface accepts data description packets from its neighbor
even if it has a different MTU size (the MTU size must be less than 18000).
■
Specify an optional process ID in the range 1–65535.
■
Example
host1(config-if)# ipv6 ospf mtu-ignore
■
Use the no version to reset the default: that the neighbor MTU size must match
the MTU size of the OSPFv3 interface from which the packet is received.
■
See ipv6 ospf mtu-ignore
ipv6 ospf network
■
Use to configure the OSPF network type for an interface.
■
Specify a network type (broadcast or point-to-point) for the interface.
■
Example
host1(config)# interface fastethernet 0/0
host1(config-if)# ipv6 ospf network broadcast
Configuring OSPF Interfaces
■ 263
Chapter 5: Configuring OSPF