Juniper IGP - CONFIGURATION GUIDE V11.1.X, Configuration Manual

Page: 313 / 454

2.
Exit Interface Configuration mode. Enter Global Configuration mode.
host1(config-subif)# exit
3.
Configure an OSPF routing process, and enter Router Configuration mode.
host1(config)# router ospf 5
4.
Specify an OSPF neighbor, and optionally assign a priority number or poll interval
to the neighbor.
host1(config-router)# neighbor 10.12.14.1 priority 5 poll-interval 180
5.
Repeat Step 4 for each neighbor in the OSPF network.
If you want to configure the network type for a specific interface or OSPF area, rather
than for all OSPF interfaces, you can use the
address network command rather than
the ip ospf network command.
address network
■
Use to configure the network type on a specific OSPF interface or for a specific
OSPF area to a type other than the default for the medium.
■
You must first issue the address area command before issuing the address
network command.
■
Example
host1(config-router)# address 10.12.10.2 network broadcast
■
Use the no version to restore the default value for the medium.
■
See address network
ip ospf network
■
Use to configure the network type on all OSPF interfaces on the OSPF network
to a type other than the default for the medium.
■
Example
host1(config-if)# ip ospf network broadcast
■
Use the no version to restore the default value for the medium.
■
See ip ospf network
neighbor
■
Use to configure OSPF neighbors on the NBMA network.
■
Specify priority and poll interval only for routers that are eligible to become the
designated router or backup designated router—that is, a router with a nonzero
router priority value. The default priority value is 0, and the default polling interval
is 120 seconds.
■
Example
Configuring OSPF for NBMA Networks
■ 289
Chapter 5: Configuring OSPF