Honda NC700 2012, Service Manual

Page: 375 / 773

12-20
dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
DTC TROUBLESHOOTING
DTC 8-1 (TP SENSOR ABNORMAL
VOLTAGE)
1. TP Sensor System Inspection
Check the TP sensor with the HDS pocket tester
when the throttle is fully closed.
Is Low voltage (about 0 V) or High voltage (about
5 V) indicated?
YES – • About 0 V: See DTC 8-1 (page 4-26)
• About 5 V: See DTC 8-2 (page 4-27)
NO – Intermittent failure
DTC 9-1 (CLUTCH LINE EOP SENSOR
LOW VOLTAGE)
• If the PCM is replaced, perform the following:
– Key Registration Procedure (page 23-6)
– Clutch Initialize Learning Procedure (page 12-120)
1. Clutch Line EOP Sensor System Inspection
Connect the HDS pocket tester and start the engine.
Check the clutch line EOP sensor with the HDS
pocket tester.
Is about 0 V indicated?
YES – GO TO STEP 2.
NO – Intermittent failure
2. Clutch Line EOP Sensor Inspection
Stop the engine.
Disconnect the clutch line EOP sensor 3P (Black)
connector.
Turn the ignition switch ON.
Check the clutch line EOP sensor with the HDS
pocket tester.
Is about 0 V indicated?
YES – GO TO STEP 3.
NO – Replace the clutch line EOP sensor with a
known good one, and recheck.
3. Clutch Line EOP Sensor Input Line Open Circuit
Inspection
Measure the voltage between the wire harness side
clutch line EOP sensor 3P (Black) connector [1]
terminals.
Is the voltage within 4.75 – 5.25 V?
YES – GO TO STEP 4.
NO – Open circuit in the Yellow/red wire
Connection: Yellow/red (+) – Green/yellow (–)
[1]
G/Y
Y/R