Honda NC700 2012, Service Manual

Page: 633 / 773

18-20
dummyhead dummyhead
REAR WHEEL/SUSPENSION
Drive the needle bearing [1] out of the left pivot using a
hydraulic press and special tool.
Remove the needle bearings [1] out of the shock
absorber bracket using the special tools.
Apply molybdenum disulfide grease to a new needle
bearing rotating area.
Install the needle bearing [1] into the left pivot with the
marked side facing up to the specified range using a
hydraulic press and special tools as shown.
Apply grease to a new ball bearing rotating area.
Install the ball bearing [1] into the right pivot with the
marked side facing out until it is fully seated using a
hydraulic press and special tools as shown.
TOOLS:
Driver, 15 x 280L [2]
07949-3710001
Pilot, 32 mm [3] 07MAD-PR90200
[2]
[1]
[3]
TOOLS:
Bearing remover set, 17 mm [2] 07936-3710300
Remover handle [3]
07936-3710100
Remover weight [4] 07741-0010201
[2] [4] [1]
[3]
TOOLS:
Driver [2]
07749-0010000
Attachment, 37 mm [3] 07ZMD-MBW0200
Pilot, 28 mm [4] 07746-0041100
4.5 – 5.0 mm
(0.18 – 0.20 in)
[3]/[4] [2]
[1]
TOOLS:
Driver [2]
07749-0010000
Attachment, 37 mm [3] 07ZMD-MBW0200
Pilot, 20 mm [4] 07746-0040500
[2]
[3]/[4]
[1]