Honda NC700 2012, Service Manual

Page: 504 / 773

14-13
dummyhead dummyhead
CRANKCASE/TRANSMISSION/BALANCER
Apply engine oil to a new left mainshaft bearing [1].
Drive the left mainshaft bearing into the upper
crankcase until it is fully seated using the special tools.
Install the removed parts in the reverse order of
removal.
TRANSMISSION ASSEMBLY
Clean all parts in solvent, and dry them thoroughly.
Apply engine oil to the gear teeth, rotating surface and
bearing.
Apply molybdenum oil solution to the spline bushing
outer surface, bushing inner and outer surface, shift fork
grooves.
Assemble the mainshaft and countershaft.
MAINSHAFT
Drive in a new
bearing squarely
with the marking
side facing toward
the inside of the
crankcase.
TOOLS:
Driver, 15 x 280L [2]
07949-3710001
Attachment, 42 x 47 mm [3] 07746-0010300
Pilot, 20 mm [4] 07746-0040500
[2]
[3]/[4]
[1]
M2 GEAR (19T)
M6 GEAR (37T)
M5 GEAR (30T)
MAINSHAFT/M1 GEAR (16T)
THRUST WASHER
M5 GEAR BUSHING
SPLINE WASHER
SNAP RING
SNAP RING
SPLINE WASHER
M6 GEAR BUSHING
LOCK WASHER
SPLINE WASHER
THRUST WASHER
M3/4 GEAR (22/25T)