Honda NC700 2012, Service Manual

Page: 459 / 773

12-104
dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
Install the right crankcase cover [1].
Install the bolts [2] with the hose clamp [3] and tighten
them in a crisscross pattern in 2 or 3 steps.
Route the wire harness and shift spindle angle sensor
wire on the right crankcase cover properly (page 1-25).
Coat a new O-ring [1] with engine oil and install it onto
the shift spindle angle sensor [2].
Install the shift spindle angle sensor by aligning the flat
surfaces of the sensor and spindle.
Install the following:
– Wire clamps [1] and bolts [2]
– Wire clip stay [3] and bolt [4]
Install the shift spindle angle sensor bolt [5] and tighten
it.
Connect the clutch EOP sensor 3P connectors [6].
(Connector with no mark to the upper sensor, connector
with "P" mark to the middle sensor and connector with
"1" mark to the lower sensor.)
Connect the CKP sensor 2P (Red) connector [1].
[1]
[3] [2]
Align
[2] [1]
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
[5] [6] [3]/[4]
[1]/[2]
[1]