Honda NC700 2012, Service Manual

Page: 449 / 773

12-94
dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
2. Shift Pedal Angle Sensor Input Voltage
Inspection
Turn the ignition switch OFF.
Disconnect the shift pedal angle sensor 3P (Black)
connector [1].
Turn the ignition switch ON and engine stop switch
" ".
Measure the voltage between the wire harness side
shift pedal angle sensor 3P (Black) connector
terminals.
Is the voltage within 4.75 – 5.25 V?
YES – GO TO STEP 4.
NO – GO TO STEP 3.
3. Shift Pedal Angle Sensor Open Circuit
Inspection
Turn the ignition switch OFF.
Connect the ECM test harness to the PCM
connectors (page 4-14).
Check for continuity between the shift pedal angle
sensor 3P (Black) connector [1] and test harness [2]
terminals.
Is there continuity?
YES – Replace the PCM with a known good one,
and recheck.
NO – • Open circuit in Green/yellow wire
• Open circuit in Yellow/red wire
4. Shift Pedal Angle Sensor Output Line Open
Circuit Inspection
Turn the ignition switch OFF.
Connect the ECM test harness to the PCM
connectors (page 4-14).
Check for continuity between the shift pedal angle
sensor 3P (Black) connector [1] and test harness [2]
terminals.
Is there continuity?
YES – GO TO STEP 5.
NO – Open circuit in Yellow/violet wire
Connection: Yellow/red (+) – Green/yellow (–)
Y/R G/Y
[1]
Connection: Green/yellow – B22
Yellow/red – B14
B14
Y/R
G/Y
B22 [1]
[2]
Connection: Yellow/violet – B19
B19
Y/V
[1]
[2]