Honda NC700 2012, Service Manual

Page: 473 / 773

12-118
dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
EOT SENSOR
REMOVAL/INSTALLATION
Disconnect the EOT sensor 2P (Black) connector [1].
Remove the EOT sensor [2] and sealing washer [3]
from the crankcase.
Apply engine oil to the EOT sensor threads and seating
surface.
Install the EOT sensor with a new sealing washer and
tighten it.
Connect the EOT sensor 2P (Black) connector.
DCT SHIFT PEDAL (OPTIONAL)
REGISTRATION (TO ENABLE THE
PEDAL)
• The following registration procedure must be
performed in order to enable the optional shift pedal.
• Make sure that the CLUTCH INITIALIZE LEARNING
(PCM) (page 12-120) is complete before starting the
registration.
• The registration will fail if any of the following
condition presents during the procedure.
– The vehicle is moved.
– The engine is started.
– The transmission is in gear.
– The shift pedal is operated incorrectly.
– The shift pedal angle sensor 3P (black) connector
is disconnected.
1. Install the shift pedal to the vehicle and connect the
shift pedal angle sensor 3P (black) connector.
2. Turn the ignition switch ON.
After 2 seconds, "S" [1] and "D" [2] indicators will
start short blinking (0.5 seconds) simultaneously.
• The short blinking lasts 5 seconds.
Within 5 seconds after blinking starts, move the shift
pedal [3] up and hold for 1 second.
Within 5 seconds after moving the shift pedal up,
move it down and hold for 1 second.
TORQUE: 14 N·m (1.4 kgf·m, 10 lbf·ft)
[1] [2]
[3]
[2] [1]
[3]
1: UP for 1 second.
2: DOWN for 1 second.
Indicators start blinking
simultaneously.