Honda NC700 2012, Service Manual

Page: 475 / 773

12-120
dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
3. After 5 seconds, the "S" and "D" indicators will start
short blinking (0.5 seconds) alternately.
If so, cancellation is successful.
Turn the ignition switch OFF.
• If the "S" and "D" indicators go OFF during the
procedure, cancellation is unsuccessful. Turn the
ignition switch OFF and perform the cancellation
procedure from step 1 again.
CLUTCH INITIALIZE LEARNING (PCM)
• If the PCM and/or clutch assembly are replaced,
perform this procedure.
• Before starting this procedure, check the following:
– PGM-FI system and DCT system have no DTC.
– Engine idle speed is normal.
– Transmission is in neutral and cooling fan stops.
• Do not operate the throttle during clutch initialize
learning
1. Warm up the engine to the normal operating
temperature (engine oil temperature: 50 – 110°C/
122 – 230°F) and stop it.
If the PCM is replaced with a new one, the "D" and "S"
indicators [1] come on to indicate that the clutch
initialize learning is necessary when the ignition switch
is turned ON. Further the large "L" [2] (extremely low oil
temperature) or small "L" [3] (low oil temperature) is
displayed on the shift indicator to indicate that the
engine warming up is necessary if it is not warmed.
Unsuccessful:
Successful:
Indicators blink alternately.
Both go OFF
Low oil temperature: Extremely low oil
temperature:
[3]
[2]
[1] [1]