Honda NC700 2012, Service Manual

Page: 130 / 773

2-35
dummyhead dummyhead
FRAME/BODY PANELS/EXHAUST SYSTEM
Install the muffler, then loosely install the muffler
mounting bolt, washer, nut and band bolt (page 2-32).
Tighten the exhaust pipe joint nuts [1] to the specified
torque in numerical order by stamped number on the
exhaust pipe joint [2] in 2 or 3 steps.
Tighten the exhaust pipe mounting nut [1] securely.
Tighten the ground wire mounting bolt [2] securely.
Install the O
2
sensor wire to the clamp [1] and radiator
reserve tank guide [2].
Route the O
2
sensor wire properly (page 1-25).
Connect the O
2
sensor 1P (Black) connector [3].
Tighten the muffler mounting nut and band bolt securely
(page 2-32).
Install the lower cowl (page 2-28).
STUD BOLT REPLACEMENT
Remove the exhaust pipe/muffler (page 2-32).
Thread two nuts onto the stud and tighten them
together, and use a wrench on them to turn the stud bolt
out.
Install new stud bolts into the cylinder head as shown.
After installing the stud bolts, check that the length from
the bolt head to the cylinder head surface is within
specification.
Install the exhaust pipe/muffler (page 2-32).
TORQUE: 28 N·m (2.9 kgf·m, 21 lbf·ft)
[2]
[1]
[2]
[1]
[1] [2] [3]
30.0 – 31.0 mm
(1.18 – 1.22 in)