Honda NC700 2012, Service Manual

Page: 381 / 773

12-26
dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
3. Shift Control Motor Condition Inspection
Remove the shift control motor (page 12-109).
Connect a fully charged 12 V battery [1] to the shift
control motor [2] 2P connector terminals to check
the motor operation.
Change the battery connection to check the reverse
operation.
Does the shift control motor turn in both
directions?
YES – GO TO STEP 4.
NO – Faulty shift control motor
4. Shift Spindle Angle Sensor System Inspection
Remove the shift spindle angle sensor with the
connector connected (page 12-116).
Turn the ignition switch ON.
While turning the shift spindle angle sensor shaft,
check the shift spindle angle sensor voltage with the
HDS pocket tester.
Does the voltage vary properly?
YES – GO TO STEP 5.
NO – Faulty shift spindle angle sensor
5. Shift Spindle Angle Sensor Condition Inspection
Check that the shift spindle angle sensor is installed
properly.
Is the shift spindle angle sensor in normal
condition?
YES – GO TO STEP 6.
NO – Install the shift spindle angle sensor
properly.
6. DTC Recheck
Recheck the DTC with the HDS pocket tester.
Is DTC 22-1 indicated?
YES – Replace the PCM with a known good one,
and recheck.
NO – Intermittent failure
DTC 23-1 (SHIFT SPINDLE
OPERATION MALFUNCTION: WHILE
OPERATING GEARSHIFT
MECHANISM)
Refer to DTC 22-1 (page 12-25)
[2] [1]
When turning the sensor shaft clockwise:
Voltage increase
When turning the sensor shaft
counterclockwise:
Voltage decrease