Honda NC700 2012, Service Manual

Page: 150 / 773

3-19
dummyhead dummyhead
MAINTENANCE
REPLACEMENT
This motorcycle uses a drive chain with a staked master
link.
Fully slacken the drive chain (page 3-17).
Remove the drive chain using the special tool.
When using the special tool, follow the manufacturer's
instruction.
Remove the excess drive chain links from a new drive
chain with the drive chain tool set.
Never reuse the old
drive chain, master
link, master link
plate and O-rings.
Insert a new master link [1] with new O-rings [2] from
the inside of the drive chain, and install a new plate [3]
and O-rings with the identification mark facing the
outside.
Assemble the master link, O-rings and plate.
Make sure that the master link pins [1] are installed
properly.
Measure the master link pin length projected from the
plate.
Stake the master link pins.
TOOL:
Drive chain tool set
07HMH-MR10103
STANDARD LINKS:
NC700X/XA/S/SA:
114 LINKS
NC700XD/SD:
112 LINKS
REPLACEMENT CHAIN
DID: DID520V0
RK: RK520MKO
NC700X/XA/S/SA: 114 LINKS
NC700XD/SD: 112 LINKS
1 LINK
TOOL:
Drive chain tool set
07HMH-MR10103
[3] [2]
[1]
STANDARD LENGTH:
Approx. 1.3 mm (0.05 in)
[1]