Honda NC700 2012, Service Manual

Page: 254 / 773

6-11
dummyhead dummyhead
ELECTRIC STARTER
GROUND LINE (NC700XD/SD)
Turn the ignition switch ON and engine stop switch " ".
Measure the voltage between the Yellow/red (+) and
Green/red (–) wire terminals at the starter relay switch
4P (Red) connector [1].
If the battery voltage appears only when the starter
switch is pushed with the ignition switch turned ON and
engine stop switch " ", the starter relay ground line is
normal.
OPERATION CHECK
Remove the starter relay switch (page 6-11).
Connect a 12 V battery to the starter relay switch as
shown.
There should be continuity between the cable terminals
when the battery is connected, and not continuity when
the battery is disconnected.
REMOVAL/INSTALLATION
Remove the maintenance lid (page 21-6).
Release the starter relay switch/shock rubber from the
battery box tabs [1].
Release the rubber cover [2].
Disconnect the starter relay switch 4P (Red) connector
[3].
Remove the bolts [4] and cables [5].
Remove the starter relay switch [6] from the shock
rubber [7].
Installation is in the reverse order of removal.
[1]
Y/R G/R
[2]
[1] [4]/[5] [7]
[3]
[6]