Honda NC700 2012, Service Manual

Page: 588 / 773

17-17
dummyhead dummyhead
FRONT WHEEL/SUSPENSION/STEERING
INSTALLATION (NC700XD/SD)
Route the wires, hoses and cables properly (page 1-
25).
Clean the inside surface of the handlebar grip and
outside surface of the handlebar and throttle pipe.
Apply Honda Bond A, Cemedine #540 or equivalent to
the inside surface of the grips and to the clean surface
of the left handlebar and throttle pipe.
Wait 3 – 5 minutes and install the grip.
Rotate the grips for even application of the adhesive.
Install the handlebar [1] onto the top bridge.
Align the handlebar punch mark with the top bridge top
surface.
Hold the handlebar and install the holder [2] and
handlebar holder bolts [3] as shown.
Tighten the upper bolts first, then the lower bolts to the
specified torque.
Apply grease to the throttle cable end and throttle pipe
flange groove.
Install the throttle pipe [1] to the handlebar.
Connect the throttle cable [2] end to the throttle pipe.
Install the right handlebar switch housing [3].
Align the switch housing locating pin with the handlebar
hole.
Install the screws [1] and tighten the upper screw first,
then tighten the lower screw to the specified torque.
Allow the adhesive
to dry for 1 hour
before using.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
[1] [2]
[3]
Align
[2]
[1] [3]
Align
TORQUE: 2.5 N·m (0.3 kgf·m, 1.8 lbf·ft)
[1]