Honda NC700 2012, Service Manual

Page: 129 / 773

2-34
dummyhead dummyhead
FRAME/BODY PANELS/EXHAUST SYSTEM
EXHAUST PIPE
REMOVAL
Remove the lower cowl (page 2-28).
Disconnect the O
2
sensor 1P (Black) connector [1].
Release the O
2
sensor wire from the clamp [2] and
radiator reserve tank guide [3].
Remove the bolt [1] and disconnect the ground wire [2].
Loosen the exhaust pipe mounting nut [3].
Remove the exhaust pipe joint nuts [4].
Remove the exhaust pipe mounting nut, bolt [5],
washers [6] and exhaust pipe [7].
Remove the exhaust pipe gasket [8].
INSTALLATION
Install a new exhaust pipe gasket [1] to the exhaust port
of the cylinder head.
Install the exhaust pipe and exhaust pipe joint nuts [2]
but do not tighten yet.
Install the exhaust pipe mounting bolt [1], washers [2]
and nut [3] but do not tighten yet.
Install the ground wire [4] and bolt [5] but do not tighten
yet.
Route the ground wire properly (page 1-25).
[2] [3] [1]
[1]/[2]
[3]
[4]
[5]/[6] [8]
[7]
[2]
[1]
[4]/[5]
[1]/[2]/[3]