Honda NC700 2012, Service Manual

Page: 145 / 773

3-14
dummyhead dummyhead
MAINTENANCE
Check that the oil filter boss protrusion from the
crankcase is specified length as shown.
If the oil filter boss is removed, apply locking agent to
the oil filter boss threads (page 3-2).
Apply engine oil to a new oil filter cartridge threads and
O-ring.
Install and tighten the oil filter cartridge [1] to the
specified torque.
Fill the engine with the recommended engine oil and
check that there are no oil leaks (page 3-12).
CLUTCH OIL FILTER (NC700XD/SD)
Replace the engine oil filter when the clutch oil filter is
replaced.
Drain the engine oil (page 3-13).
Remove the lower cowl (page 2-29).
Remove the following:
– Bolts [1]
– Clutch oil filter cover [2]
– Spring [3]
– Clutch oil filter [4]
– O-ring [5]
Install a new clutch oil fitter with the "OUTSIDE" mark
[6] facing out.
Installation is in the reverse order of removal.
• Replace the O-ring with a new one.
• Apply engine oil to a new O-ring.
Fill the engine with the recommended engine oil and
check that there are no oil leaks (page 3-12).
SPECIFIED LENGTH: 16.5 ± 0.5 mm (0.65 ± 0.02 in)
16.5 ± 0.5 mm
(0.65 ± 0.02 in)
TORQUE: 26 N·m (2.7 kgf·m, 19 lbf·ft)
[1]
[1]
[2]
[3]
[4]
[6]
[5]