Honda NC700 2012, Service Manual

Page: 200 / 773

4-39
dummyhead dummyhead
PGM-FI SYSTEM
2. Bank Angle Sensor Power Input Voltage
Inspection
Turn the ignition switch OFF.
Disconnect the bank angle sensor 2P (Black)
connector [1].
Turn the ignition switch ON.
Measure the voltage at the bank angle sensor
connector of the wire harness side and ground.
Does the standard voltage exist?
YES – GO TO STEP 3.
NO – Open circuit in the Black/white wire
3. Bank Angle Sensor Output Line Short Circuit
Inspection
Turn the ignition switch OFF.
Disconnect the following:
– ECM 33P (Black) connector (NC700X/XA/S/SA)
– PCM 33P (Gray) connector (NC700XD/SD)
Check for continuity between the bank angle sensor
2P (Black) connector [1] of the wire harness side
and ground.
Is there continuity?
YES – Short circuit in the Black/blue wire
NO – GO TO STEP 4.
4. Bank Angle Sensor Output Line Open Circuit
Inspection
Check for continuity between the ECM/PCM 33P
connector [1] and bank angle sensor 2P (Black)
connector [2] of the wire harness side.
Is there continuity?
YES – • Inspect the bank angle sensor (page 4-
66).
• Replace the ECM/PCM with a known
good one, and recheck.
NO – Open circuit in the Black/blue wire
Connection: Black/white (+) – Ground (–)
Standard:
Battery voltage
Bl/W
[1]
Connection: Black/blue – Ground
Bl/Bu
[1]
Connection: Black/blue – Black/blue
TOOL:
Test probe
07ZAJ-RDJA110
[1] [2]
Bl/Bu
Bl/Bu