Honda NC700 2012, Service Manual

Page: 299 / 773

9-4
dummyhead dummyhead
LUBRICATION SYSTEM
SERVICE INFORMATION
GENERAL
• This section covers service of the oil pump and oil strainer.
• The oil pump and oil strainer can be serviced with the engine installed in the frame.
• The service procedures in this section must be performed with the engine oil drained.
• When removing and installing the oil pump, use care not to allow dust or dirt to enter the engine.
• If any portion of the oil pump is worn beyond the specified service limits, replace the oil pump as an assembly.
• After the oil pump has been installed, check that there are no oil leaks and that oil pressure is correct.
SPECIFICATIONS
Unit: mm (in)
TORQUE VALUE
Used engine oil may cause skin cancer if repeatedly left in contact with the skin for prolonged periods. Although this is unlikely
unless you handle used oil on a daily basis, it is still advisable to thoroughly wash your hands with soap and water as soon as
possible after handling used oil.
ITEM STANDARD SERVICE LIMIT
Engine oil
capacity NC700X/XA/S/SA After draining 3.1 liters (3.3 US qt, 2.7 Imp qt) –
After draining/
filter change
3.4 liters (3.6 US qt, 3.0 Imp qt) –
After
disassembly
3.7 liters (3.9 US qt, 3.3 Imp qt) –
NC700XD/SD After draining 3.2 liters (3.4 US qt, 2.8 Imp qt) –
After draining/
filter change
3.4 liters (3.6 US qt, 3.0 Imp qt) –
After
disassembly
4.1 liters (4.3 US qt, 3.6 Imp qt) –
Recommended engine oil Honda "4-stroke motorcycle oil" or an
equivalent
API service classification: SG or higher
(except oils labeled as energy conserving
on the circular API service label)
Viscosity: SAE 10W-30
JASO T 903 standard: MA
–
Oil pressure at engine oil filter 470 kPa (4.8 kgf/cm
2
, 68 psi)
at 5,000 min
-1
(rpm)/(80°C/176°F)
–
Oil pump rotor (NC700X/XA/S/SA) Tip clearance 0.15 (0.006) 0.20 (0.008)
Body clearance 0.15 – 0.21 (0.006 – 0.008) 0.35 (0.014)
Side clearance 0.04 – 0.09 (0.002 – 0.004) 0.12 (0.005)
Engine oil pump rotor (NC700XD/SD) Tip clearance 0.15 (0.006) 0.20 (0.008)
Body clearance 0.15 – 0.21 (0.006 – 0.008) 0.35 (0.014)
Side clearance 0.04 – 0.09 (0.002 – 0.004) 0.12 (0.005)
Clutch oil pump rotor (NC700XD/SD) Tip clearance 0.15 (0.006) –
Body clearance 0.15 – 0.21 (0.006 – 0.008) –
Side clearance 0.04 – 0.09 (0.002 – 0.004) –
ITEM Q'TY
THREAD TORQUE
REMARKS
DIA. (mm) N·m (kgf·m, lbf·ft)
Engine oil filter cartridge 1 20 26 (2.7, 19) Apply engine oil to the threads.