Honda NC700 2012, Service Manual

Page: 726 / 773

22-3
dummyhead dummyhead
LIGHTS/METERS/SWITCHES
SERVICE INFORMATION
GENERAL
• Note the following when replacing the halogen headlight bulb.
– Wear clean gloves while replacing the bulb. Do not put fingerprints on the headlight bulb, as they may create hot spots on the
bulb and cause it to fail.
– If you touch the bulb with your bare hands, clean it with a cloth moistened with alcohol to prevent its early failure.
• Be sure to install the dust cover after replacing the headlight bulb.
• A halogen headlight bulb becomes very hot while the headlight is ON, and remains hot for a while after it is turned OFF. Be sure
to let it cool down before servicing.
• Check the battery condition before performing any inspection that requires proper battery voltage.
• Use an electric heating element to heat the water/coolant mixture for the ECT sensor inspection. Keep flammable materials
away from the electric heating element. Wear protective clothing, insulated gloves and eye protection.
• A continuity test can be made with the switches installed on the motorcycle.
• The following color codes are used throughout this section.
SPECIFICATIONS
TORQUE VALUES
Bu = Blue G = Green P = Pink V = Violet Y = Yellow
Bl = Black Gr = Gray R = Red W = White
ITEM SPECIFICATIONS
Bulbs Headlight 12 V – 60/55 W
Position light 12 V – 5 W
Brake/tail/license light 12 V – 21/5 W
Turn signal light 12 V – 21 W x 4
Instrument light LED
Turn signal indicator LED
High beam indicator LED
Neutral indicator LED
Engine oil pressure indicator LED
High coolant temperature indicator LED
MIL LED
HISS indicator LED
ABS indicator (NC700XA/XD/SA/SD) LED
Parking brake indicator (NC700XD/SD) LED
Fuse Main fuse 30 A
PGM-FI fuse 15 A
Sub fuse 15 A x 2, 7.5 A x 4
ABS fuse (NC700XA/XD/SA/SD) 30 A x 2, 7.5 A
DCT fuse (NC700XD/SD) 30 A, 7.5 A
ECT sensor resistance 40°C (104°F) 1.0 – 1.3 k
Ω
100°C (212°F) 0.1 – 0.2 k
Ω
Fuel level sensor resistance Full 4 – 6
Ω
Empty 80 – 83
Ω
ITEM Q'TY
THREAD TORQUE
REMARKS
DIA. (mm) N·m (kgf·m, lbf·ft)
Turn signal light mounting screw 4 6 2.5 (0.3, 1.8)
Combination meter mounting
screw 3 5 1.0 (0.1, 0.7)
Combination meter back cover
mounting screw (NC700S/SA/SD) 4 3 0.3 (0.03, 0.2)
EOP switch 1 PT 1/8 18 (1.8, 13) Apply sealant to the threads.
Ignition switch mounting bolt 2 8 25 (2.5, 18) One way bolt; replace with a new
one.
Neutral switch 1 10 12 (1.2, 9)
Parking brake switch screw
(NC700XD/SD) 1 4 1.2 (0.1, 0.9)