Honda NC700 2012, Service Manual

Page: 354 / 773

11-19
dummyhead dummyhead
CLUTCH/GEARSHIFT LINKAGE (NC700X/XA/S/SA)
Install the washer [1] and gearshift spindle [2].
Align the return spring ends with the spring pin.
Install the following:
– Right crankcase cover (page 11-5)
– Left rear cover (page 2-29)
GEARSHIFT PEDAL
REMOVAL/INSTALLATION
Loosen the gearshift pedal adjuster lock nuts [1] and
remove the tie-rod [2].
Remove the gearshift pedal pivot bolt [3] and gearshift
pedal [4].
Remove the dust seals [1].
Installation is in the reverse order of removal.
• Apply grease to the gearshift pedal pivot and dust
seal lips.
• Apply grease to the gearshift pedal tie-rod ball joint
area.
Adjust the tie-rod length so that the distance between
the ball joint ends is standard length as shown.
After adjustment tighten the gearshift pedal adjuster
lock nut [1] to the specified torque.
[2]
[1]
Align
[1] [3]
[4] [2]
[1]
TORQUE:
Gearshift pedal pivot bolt:
27 N·m (2.8 kgf·m, 20 lbf·ft)
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
91.1 mm (3.59 in)
8 mm (0.3 in)
[1]
[1]