Honda NC700 2012, Service Manual

Page: 133 / 773

3-2
dummyhead dummyhead
MAINTENANCE
MAINTENANCE
SERVICE INFORMATION
GENERAL
• Place the motorcycle on level surface before starting any work.
• Gasoline is extremely flammable and is explosive under certain conditions.
• Work in a well ventilated area. Smoking or allowing flames or sparks in the work area or where the gasoline is stored can cause
a fire or explosion.
• The exhaust contains poisonous carbon monoxide gas that may cause loss of consciousness and may lead to death. Run the
engine in an open area or with an exhaust evacuation system in an enclosed area.
TORQUE VALUES
ITEM Q'TY
THREAD TORQUE
REMARKS
DIA. (mm) N·m (kgf·m, lbf·ft)
Air cleaner housing cover screw 6 5 1.1 (0.1, 0.8)
Spark plug 2 14 22 (2.2, 16)
Valve adjusting screw lock nut 8 7 14 (1.4, 10) Apply engine oil to the threads and
seating surface.
Camshaft maintenance cap 1 36 4.0 (0.4, 3.0) See page 3-12
Timing hole cap 1 14 10 (1.0, 7) Apply grease to the threads.
Crankshaft hole cap 1 30 15 (1.5, 11) Apply grease to the threads.
Engine oil drain bolt 1 12 30 (3.1, 22)
Engine oil filter cartridge 1 20 26 (2.7, 19) Apply engine oil to the threads.
Oil filter boss 1 20 – See page 3-14
Apply locking agent to the threads.
Coating width; 6.5 ± 1.0 mm (0.26 ±
0.04 in) from tip
Rear axle nut 1 18 98 (10.0, 72) U-nut
Drive chain adjuster lock nut 2 8 21 (2.1, 15)
Drive sprocket bolt 1 10 54 (5.5, 40)
Driven sprocket nut 5 12 108 (11.0, 80) U-nut
Master cylinder reservoir cover
screw 4 4 1.5 (0.2, 1.1)
Rear brake reservoir mounting bolt 1 6 10 (1.0, 7)
Rear master cylinder push rod lock
nut 1 8 17 (1.7, 13)
Parking brake adjuster bolt lock
nut (NC700XD/SD) 1 8 17 (1.7, 13)
Sidestand pivot bolt 1 10 – See page 3-27
Apply grease to the sliding surface.
Sidestand pivot nut 1 10 39 (4.0, 29) U-nut
Sidestand switch bolt 1 6 10 (1.0, 7) ALOC bolt; replace with a new one.