Hill-Rom P870, Manual

Page: 38 / 231

Resident TM LTC Electric Drive Bed Specifications
Chapter 1: Introduction
Resident
TM
LTC Bed Service Manual (man136rc) Page 1 - 25
1
The Resident
TM
LTC electric drive bed operates on 120V AC, 60 Hz, single
phase power.
The electrical power system is mechanically insulated from the metal parts of
the bed. No additional electrical components, such as isolation transformers,
are required to make this bed meet applicable electrical codes.
Each bed is factory tested for complete operation with and without load. Each
bed is tested for insulation integrity and micro leakage currents. Before
shipment, each bed must indicate less than 100 micro amperage leakage
current ungrounded.
The electrical supply cord (to the wall outlet) is #18 AWG low leakage, UL
approved, two conductor with ground, type SJT. It extends approximately 116"
(294.6 cm) from the head end of the bed.
Handset Control
The handset control provides electrical control of the head, knee, and hilow
elevation. The buttons on the handset are pictorially labeled to indicate their
function.
Siderail Resident Control Panel
An optional resident siderail control panel can be installed on the inside of both
head end siderails for convenience. The resident can control the head and knee
functions with the pictorially labeled activator buttons on both panels.
Siderail Caregiver Control Panel
An optional caregiver siderail control panel can be installed on the outside of
both head end siderails. The control activators face the caregiver, minimizing
accessibility to the resident. The bed’s hilow function can be controlled
through the manipulation of pictorially labeled activator buttons on either
panel.
Control Box Lockout
WARNING:
Whenever a resident should be restricted from operating the resident or
handset controls, activate the appropriate control lockout knob to
prevent operation of the function. Otherwise, personal injury may occur.