Hill-Rom P870, Manual

Page: 132 / 231

4.7 Automatic Contour Module
Chapter 4: Removal, Replacement, and Adjustment Procedures
Resident
TM
LTC Bed Service Manual (man136rc) Page 4 - 25
4
Adjustment
1. With the automatic contour module installed on the bed and its cover
removed, plug the bed into an appropriate power source.
2. Press the HEAD Up button to raise the head. Check the head angle
indicator decals (located at both sides of the bed on the sleep surface) to
observe the degree at which the knee section stops rising. This should be
approximately 15
o
. Continue to raise the head section until clearance exists
between the sleep surface crosstube and the plunger at the head end side of
the automatic contour module.
3. Press the HEAD Down button to lower the head section. Check the head
angle degree at which the knee section begins to lower. This should be
approximately 15
o
. Continue to lower the head and knee sections to the flat
position.
4. If adjustment is necessary:
a. Loosen, do not remove, the two screws (A) securing the automatic
contour module to the weldment bracket (see figure 4-20 on page
4-25).
Figure 4-20. Automatic Contour Module—Cover Removed
A
A
m136_067