Hill-Rom P870, Manual

Page: 131 / 231

4.7 Automatic Contour Module
Chapter 4: Removal, Replacement, and Adjustment Procedures
Page 4 - 24 Resident
TM
LTC Bed Service Manual (man136rc)
4
Figure 4-19. Automatic Contour Module—Internal Wire Connections
3. Check that the wires (B, C, E, and F) are connected to the microswitches
inside the automatic contour module. The green wire (B), blue wire (C),
white wire (E), and orange wire (F) connect as shown.
4. Ensure that all cables are properly routed, and the automatic contour
module cable (A) is connected to the control lockout box (see figure 4-17
on page 4-22).
5. Install cable ties to secure the control cables where they will not be
damaged during bed operation.
6. Perform an operational check of the automatic contour functions (see
“Function Checks—Electric Drive Model” on page 2-10). Adjust the
module as necessary (see “Adjustment” on page 4-25).
B
A
D
E
C
F
m136_066