Gambro AK 98, Operator'S Manual

Page: 67 / 386

HCEN12745 Revision 10.2016
Program version 2.xx
AK 98 Dialysis Machine - Handling the dialysis machine A:65
Conc
●
Concentrate
: Set the combination of concentrates to be connected.
●
Empty BiCart
: Empty the water from BICART cartridge. This reduces leakage
when the cartridge is disconnected. (Not available during treatment).
Temp
●
Fluid temperature
: Set the dialysis fluid temperature.
●
Low alarm limit
: Set the low alarm limit for the dialysis fluid temperature.
●
High alarm limit
: Set the high alarm limit for the dialysis fluid temperature.
●
Actual dialysis fluid temperature
: Read out of the actual dialysis fluid
temperature.
Cond
●
Na
+
: Set the dialysis fluid sodium value.
●
HCO
3
-
: Set the dialysis fluid bicarbonate value.
●
Profiling
: Set the ultrafiltration profile, see Section 7.1 “General” on page A:118.
●
Calculated conductivity (C/P)
: Calculated dialysis fluid conductivity (C/P
Control/Protective values), based on the settings for sodium and bicarbonate.
●
Actual conductivity (C/P)
: Read out of the actual dialysis fluid conductivity
(C/P Control/Protective values).
Fluid flow
●
Dialysis fluid flow
: Set the dialysis fluid flow rate. The value can be set
during priming, but will not take effect until treatment start.
●
Concentrate standby mode
: Activate standby mode to pause the preparation of
dialysis fluid, see Section 3.5 “Concentrate standby mode” on page A:70.