Fuji Electric ALPHA7, User Manual

Page: 72 / 662

CHAPTER 2 WIRING
Encoder
2-25
2
[3] Wrap vinyl tape 2 to 3 times around approximately 10
mm of the base of the braided wire for insulation.
[4] Wrap the battery board wiring 2 to 3 times around the
shield wire, and pass through the thermal contraction
tube.
[5] Leave approximately 7 mm of the braided wire, and
contract the thermal contraction tube.
[6] Fold back 6 to 8 mm of the braided wire.
[7] Wrap copper foil tape 2 to 3 times around the braided
wire.
[8] Solder the encoder cable core wire and battery board
wiring to the plug housing body.
Fitting a tube to each soldered part ensures safety.
[9] Secure the plug housing body to the plug shell cover.
[10] Secure the cable clamp from the rear with screws.
[11] Fit the plug shell body while aligning the clips on both
sides.
[12] Turn over the connector, and secure by aligning the clip
position with plug mold cover (A).
[13] Secure plug mold cover (B) by aligning the clips at 4
locations. When doing so, take care not to trap the
wires.
[14] Use the nylon clip to hold down the encoder cable, and
secure to battery case (A) with a screw from the top, and
a nut from the rear.
[15] Connect the battery board wiring to CN3.
2
4
6
Vinyl tape
Thermal contraction tube
7
Copper foil tape
Plug housing body
Plug shell cover
Cable clamp
Plug shell body
Plug mold cover (A)
Plug mold cover (B)
Nylon clip
CN3
Battery board wiring
Screw
Clip
Battery case (A)