Fuji Electric ALPHA7, User Manual

Page: 405 / 662

CHAPTER 6 KEYPAD
6-52
Test Operation Mode
6
4
(13) Profile operation
Operate the servomotor continuously. Once started, reciprocal operation (depending on parameter
PA1_23) continues until operation is stopped.
Continuous operation is possible even if cables to the host control unit are not connected. Use this
mode to check the effective torque or for other purposes.
Operation
pattern name
Travel
distance
Operation
frequency Acceleration
time
Deceleration
time
Rotation
speed
Timer
Direction of rotation
Go path
Return
path
Profile
operation
PA1_20 Endless PA1_37 PA1_38 PA1_21 PA1_22 PA1_23
SET
(1秒以上)
ESC
試運転名
NG
表示例
NG 表示となった場合は
「■
NG
表示」を
参照ください。
オフライン切換
ESC
SET
(1秒以上)
中断終了
実行中は 1 番左桁の
点灯バーが
8
の字に動きます。
再度
[ESC]
キーを押すと、オンライン切換して
試運転名表示へ戻ります。
SET
(1秒以上)
ESC
実行中
ESC
運転停止
・ 往復運転の場合は、復路の動作終了まで運転を継続
・ 片方向運転の場合は、現在の動作終了まで運転を継続）
Fn_13
Ptn
nG5 -
8 StoP
_StoP
_ _ Ptn
8 - Ptn
SET
(1 sec. or over)
SET
(1 sec. or over)
SET
(1 sec. or over)
Press the [ESC] key again to change to online and return
to the test operation name display.
The illumination bar at the leftmost digit
moves to 8 during execution.
If NG displayed, refer to
“■ NG indication”.
NG indication example
Test operation name
Changes to offline mode
During execution
Termination
complete
Operation stop

If performing reciprocal operation, the motor continues to run until
the return movement is complete.

If performing one way operation, the motor continues to run until
the current movement is complete.