Fuji Electric ALPHA7, User Manual

Page: 341 / 662

CHAPTER 5 SERVO ADJUSTMENT
5-24
Profile Operation
5
 In case of operation at keypad
The following procedure illustrates how to perform profile operation from the keypad.
SET
(1秒以上)
ESC
試運転名
NG 表示例
オフライン切換
ESC
SET
(1秒以上)
中断終了
実行中は
1
番左桁の
点灯バーが
8
の字に動きます。
再度 [ESC] キーを押すと、即サーボオフ、
オンライン切換して試運転名表示へ戻ります。
SET
(1秒以上)
ESC
実行中
ESC
運転停止
・ 往復運転の場合は、復路の動作終了まで運転を継続
・ 片方向運転の場合は、現在の動作終了まで運転を継続）
Fn_13
Ptn
nG5 -
8 StoP
_StoP
_ _ Ptn
8 - Ptn
NG
表示となった場合は
「 6.9
運転モード
」の
中の「■
NG
表示」を
参照ください。
SET
(1 sec or longer)
Trial operation name
Changes to offline mode
Operation stop
● If performing reciprocal operation, operation is continued until the return
operation is complete.
● If performing one direction operation, operation is continued until the
current operation is complete.
If NG displayed, refer to
“■ NG indication ” in “ 6.9
Test Operation Mode ” .
NG indication example
The illumination bar at the leftmost
digit moves to 8 during execution.
SET
(1 sec or longer)
SET
(1 sec or
longer)
Executing
By pressing [ESC] again, the servo turns OFF
immediately, the mode changes to online, and
the trial operation name is displayed again.
Termination
complete