Fuji Electric ALPHA7, User Manual

Page: 14 / 662

xiii
PA2_78 Display transition at warning detection ··········································· 4-93
PA2_80 to 85 Parameter in RAM 1 to 6 ····················································· 4-94
PA2_86 to 88 Positioning data in RAM 1 to 3 ·············································· 4-94
PA2_89 and 90 Sequence test mode: Mode selection and encoder selection ···· 4-95
PA2_93 Parity/stop bit selection (for Modbus) ············································· 4-95
PA2_94 Response time (for Modbus) ······················································· 4-96
PA2_95 Communication time over time (for Modbus) ··································· 4-96
PA2_97 Communication protocol selection ················································ 4-96
4.6 Input Terminal Function Setting Parameters ····························· 4-97
4.6.1 List (PA3_

) ·································································· 4-97
4.6.2 Description of Each Parameter ·············································· 4-99
PA3_01 to 24 CONT signal assignment ····················································· 4-99
PA3_48 to 49 CONT CA assignment/CONT CB assignment ·························· 4-99
PA3_25 CONT signal inversion ······························································ 4-102
PA3_50 CONT CA/CB signal inversion ···················································· 4-102
PA3_26 to 30 CONT always ON 1 to 5 ····················································· 4-103
PA3_31 to 34 Speed and torque command scale and offset settings ·············· 4-104
PA3_35 Zero clamp level ······································································ 4-104
PA3_36 Deviation clear input form ·························································· 4-104
PA3_39 Speed command fine adjustment gain ·········································· 4-105
PA3_40 Torque command fine adjustment gain ········································· 4-105
PA3_41
～
44 Address free assignment 1 to 4 (for Modbus) ··························· 4-105
4.7 Output Terminal Function Setting Parameters ························· 4-107
4.7.1 List (PA3_

) ································································ 4-107
4.7.2 Description of Each Parameter ············································ 4-109
PA3_51 to 71 OUT signal assignment ······················································ 4-109
PA3_98 OUT FZ assignment ································································· 4-109
PA3_72 OUT signal inversion ································································ 4-112
PA3_99 OUT FZ signal inversion ···························································· 4-112
PA3_81 to 87 Monitor output scale and offset settings ································· 4-113
PA3_88 Command pulse frequency sampling time for monitor ······················ 4-115
PA3_89 Feedback speed sampling time for monitor ···································· 4-116
PA3_90 Output pulse frequency error ······················································ 4-116
PA3_92 Range1 of position: Setting1 ······················································· 4-116
PA3_93 Range1 of position: Setting2 ······················································· 4-116
PA3_94 Range2 of position: Setting1 ······················································· 4-116
PA3_95 Range2 of position: Setting2 ······················································· 4-116
4.8 Extension Function 2 Setting Parameters ······························· 4-117