Foma D902iS, Manual

Page: 488 / 517

3
Communication configuration file (driver)
Install the communication configuration file on a PC
from the attached CD-ROM, before connecting
FOMA terminal to a PC to perform packet
communication or 64K data communication.
FOMA PC configuration software
When the FOMA PC configuration software (found on
the CD-ROM) is installed on a PC, a number of
settings required for data communication via
connection between FOMA terminal and PC can be
made from the PC by simple operation.
Checking operating environment
Use the communication configuration file and the
FOMA PC configuration software in the following
operating environments:
*1 USB port (conform to USB specification 1.1/2.0) is
required.
INFORMATION
● Note that utilization may not be possible in certain
operating environments. Furthermore, operation will
not be guaranteed in an environment other than that
described above or by upgrading. And DoCoMo
assumes no responsibility for operation under such
conditions.
● In this manual, Windows 98 and Windows 98SE are
collectively shown as Windows 98.
Before installation/uninstallation
･
Installing and uninstalling the communication
configuration file or the FOMA PC configuration
software under Windows XP or 2000 can only be
performed by a user with administrator privileges.
Attempts made by other users will result in errors.
For details on PC administrator privileges, refer to
the instruction manual of the PC or contact your PC
manufacturer or Microsoft Corporation.
･
Before starting operation, make sure that no other
program is running. If there is any active program,
save and exit the program before operation.
Connecting PC to FOMA terminal
The connection should be made with the PC and
FOMA terminal both switched on.
･
Be sure to install the communication configuration
file (driver) before connecting with a PC in
communication mode.
☛
P4
Connecting a PC
Connect by using the FOMA USB cable (optional).
a
Open the cap on the FOMA terminal’s
external connection terminal
b
Insert one end of the FOMA USB cable into
the FOMA terminal’s external connection
terminal until it clicks
c
Insert the other end of the FOMA USB cable into
the PC USB connector
･
When a PC and FOMA terminal are connected in
communication mode,
appears on the
display of FOMA terminal.
･
If you connect FOMA terminal to a PC in
communication mode before installing the
communication configuration file, Windows may
automatically detect that a FOMA USB cable has
been inserted, request to install a driver, and the
wizard screen will be displayed. In that case,
remove FOMA terminal and click
キャンセル
(Cancel) to exit the wizard.
■
Removing FOMA USB cable
Press release buttons on both sides of the
connector for FOMA terminal and pull it out. Pull
the connector for PC out from the side of PC.
Item Requirements
PC*
1
PC/AT compatible computer
OS The Japanese version of
Windows 98, Me, 2000 or XP
Memory
requirements Windows 98, Me: 32MB or more
Windows 2000: 64MB or more
Windows XP: 128MB or more
Hard disk capacity 5 MB or more free disk space
Connector
(label facing up)
Release
button
USB connector
Next