Foma D902iS, Manual

Page: 48 / 517

46
Be
for
e
Using D90
2
iS
1
Hold down
f
for over 2 seconds
The wake-up screen appears and then the standby display is displayed. Displaying the wake-up screen
may take some time.
1
Hold down
f
for over 2 seconds
INFORMATION
●
When you turn on the power of FOMA terminal after replacing the UIM (except when Omakase Lock (Remote Lock) is set),
entry of the 4 to 8-digit terminal security code is required. After entering the correct PIN1 code, the standby display appears. If
a wrong terminal security code is entered 5 times consecutively, the power is turned off (can be turned on again).
●
Calls may be cut off even when is indicated and you are not moving.
●
When PIN1 Code ON/OFF is set to
ON
, entry of the PIN1 code is required.
●
When Reset Call Cost is set to ON , entry of the PIN2 code is required.
●
When
Normal use
of
Display light time
in Display Light Setting is set to other than
Always
, if you do not press any keys for
about 90 seconds, the display disappears. This also applies during a voice call. If there is any key operation*
1
(except
rotating the Speed Selector) or an incoming call, the display appears again.
･
The display does not disappear in following cases: during a videophone call, when the shooting screen of Camera/
Movie Camera is displayed, while shooting, while charging with
AC adapter connected
of
Display light time
set to
Always
on , or while executing the function for which Display light time is set to Always on .
*1 Pressing dial keys does not enter numbers, except during a call.
Switching to English display
Select Language
1
m8272
2
Press
2
･
To switch to Japanese display:
1
INFORMATION
●
The setting is saved in the UIM.
Turning the power on
Turning the power off
Default Japanese
Battery level icon
･
If the date and time have not been set, a message indicating that
is displayed. When FOMA terminal receives the time information
and the time is automatically corrected, the message disappears.
Press
o
to set the date and time manually.
･
If no UIM is inserted, a message indicating that insertion of the
UIM is required is displayed. Turn the power off, insert the
UIM and then turn the power back on.
･
The following items can be changed:
・
Standby image
☛
P136
・
Battery level icon
☛
P147
・
Time display format
☛
P151
Icon
Received
signal level
Strong Weak Outside the service area
and where radio waves
are hard to reach
is indicated while reading the UIM and
disappears when reading is completed.
Date/day/time
Received
signal level
The standby
image is
displayed.
Select
Language
Note: The miniSD memory card is not included in the bundle and needs to be purchased.
☛
P331