Foma D902iS, Manual

Page: 489 / 517

4
･
Be sure to press release buttons on both sides
of the connector when pulling it out for FOMA
terminal. Forcing to pull it out may cause a
malfunction.
FOMA terminal can be connected using a desktop
holder (optional) during the charging. However,
charging time becomes longer.
a
Connect the desktop holder to the AC
adapter
･
Plug the AC adapter into the wall outlet
b
Connect FOMA terminal and FOMA USB
cable
c
Along with the desktop holder, insert FOMA
terminal at an angle as shown in the figure
･
Pull out the FOMA USB cable in front of the
desktop holder, when inserting FOMA terminal.
･
Check that the Enter key lights in red.
INFORMATION
●
FOMA terminal can be connected in communication
mode by using a data communication adapter
D01(optional), while charging. However, charging
time becomes longer.
●
Do not remove the FOMA USB cable during data
communication, or give shock to FOMA terminal and
desktop holder. It may cause the interruption of
charging or data communication, malfunction or
failure of PC or FOMA terminal, or loss of data.
●
Starting to charge during data communication may
not complete charging. To complete charging, it is
recommended that you end the data communication
first, and then start charging.
Installation of the communication
configuration file (driver)
Install the communication configuration file onto a
PC before connecting FOMA terminal to the PC
to perform communication.
Installing the communication configuration file
Before operation, read “Before installation/
uninstallation”
☛
P3
･
Perform Steps 1 to 3 first, and then connect
FOMA terminal to a PC.
1
Insert the attached CD-ROM into a PC
The
ソフトウェアのセットアップ
(Software
setup) screen appears.
2 Click 通信設定ファイル (Communication
configuration file)
3 Click インストール開始 (Start installation)
A screen requesting to connect FOMA D902iS to
the PC appears.
4
Connect FOMA terminal to the PC
A progress screen for installation appears and
automatically completed.
･
Connect FOMA terminal while the power is on.
･
Go to “Checking the communication
configuration file”, and check the type and
name of the device installed.
INFORMATION
● Installation may take a few minutes.
● When Windows rebooting is prompted on the screen,
follow the instruction and reboot.
● If a PC and FOMA terminal are connected before
the communication configuration file is installed,
another driver may be automatically installed. When
this happens, performing the operation in Step 2
displays a message saying that the installed driver
must be uninstalled. In this case, uninstall the driver
following instruction shown on the display and install
the communication configuration file.
Checking the communication configuration file
When the PC does not detect FOMA terminal
correctly, settings and communication cannot be
performed.
Connecting while charging
Desktop holder
Enter key
FOMA USB cable connector
for FOMA terminal
(label facing up)
AC adapter connector
( facing up)
Next